Polygonal sculpture “Cerberus”

The sculpture is made in polygonal technique from 1.5 mm steel and painted with a fur imitation effect. The “head” contains an Arduino-based control unit, and a motion sensor (range 7 meters) is installed in the chest. A hidden power connector is located at the back. It can be used without connection to the mains. When connected via the power supply (included), the eyes light up red upon motion detection and fade out afterwards. Suitable for outdoor use; the model is fully sealed. To prevent condensation, wooden elements (moisture absorbers) are installed inside, and the electronics are sealed with silicone. Input voltage after the power supply is 5 volts, making it completely safe. It can be sat on; tested with a person weighing 174 kg.