Polygonal sculpture “Doberman”

The sculpture is made using a polygonal technique from 1.5 mm steel and finished with a hand-painted fur effect. Leather pads are attached to the paws to prevent scratching the floor. The “head” contains an Arduino-based control unit, while the chest houses a motion sensor (7 meters), covered with a handcrafted key element. A hidden power connector is located at the back. It can be used without connection to the mains. When connected via the power supply (included), the eyes light up red upon motion detection and fade out afterwards. Suitable for outdoor use; the model is fully sealed. To prevent condensation, wooden elements (moisture absorbers) are installed inside, and the electronics are sealed with silicone. Input voltage after the power supply is 5 volts, making it completely safe.